Electrical – kicad problem: Unconnected pads

kicadpcbpcb-design

enter image description here

I finished the routing and the copper pour but this problem showed up.
I don't know what this even means, i thought some pours are not connected to ground so i connected jumpers between them the outter pour but nothing new happend.

enter image description here

I know it looks stupid but that's my first pcb ever and i feel like i don't know what i'm doing. Anyway, here's a photo of the pcb and the routing without the pour and i hope for any helpful comments over the full design…

enter image description here
enter image description here

Best Answer

Whay are you want to achieve with connecting GND-GND with jumper? If you need two grounds (analog/digital) you need two symbols (e.g. GND-SGND). Also I did not get R9 10k resistor Vdd-GND, is it permanent load ? Anyway I think the "island" GND (with U2-13) is not connected to outer GND by a PCB wire so it complains, i.e. what are you asking for. But from my point schema generally makes no sense.