MATLAB: Is it not possible to generate code from simulink model on DSKC6713 using CCSv3.1

ccsv3.1simulink

When i try to build a model in simulink,I am getting the following error :
"Could not connect to the board specified in target preferences block" "This version of the embedded IDE link does not support your version of CCS IDE"
If anyone knows the solution for this,plz do reply immediately. Thanks in advance

Best Answer

  • No, it is possible, given a MATLAB version old enough to still have supported CCSv3.1 . See http://www.mathworks.com/matlabcentral/newsreader/view_thread/263581
  • Related Question