MATLAB: Is the upper limit of the Y-axis in the loglog plot wrong, after I attempt to set it using handle graphics

limitsloglogMATLABytick

In general, the axis limits shown do not include the last value that I tried to set using handle graphics. In the example given below, the upper limit on the loglog plot is .1 less than it should be. In this case 0.6 should be the maximum Y value, but is not shown.
Example:
t=linspace(.1,.6,65);
loglog(t(2:65)) % loglog(t) % no error
set(gca,'ytick',.1:.1:1)
Using the entire range of 't' does not cause the error, i.e.:
t=linspace(.1,.6,65);
loglog(t)
set(gca,'ytick',.1:.1:1)

Best Answer

  • This bug has been fixed in Release 14 Service Pack 3 (R14SP3). For previous product releases, read below for any possible workarounds:
    As a workaround, it is possible to set the axes limits using the property editor in the figure window.