5.9 RN procedures

36.3313GPPEvolved Universal Terrestrial Radio Access (E-UTRA)Protocol specificationRadio Resource Control (RRC)Release 15TS

5.9.1 RN reconfiguration

5.9.1.1 General

Figure 5.9.1.1-1: RN reconfiguration

The purpose of this procedure is to configure/reconfigure the RN subframe configuration and/or to update the system information relevant for the RN in RRC_CONNECTED.

5.9.1.2 Initiation

E-UTRAN may initiate the RN reconfiguration procedure to an RN in RRC_CONNECTED when AS security has been activated.

5.9.1.3 Reception of the RNReconfiguration by the RN

The RN shall:

1> if the rn-SystemInfo is included:

2> if the systemInformationBlockType1 is included:

3> act upon the received SystemInformationBlockType1 as specified in 5.2.2.7;

2> if the SystemInformationBlockType2 is included:

3> act upon the received SystemInformationBlockType2 as specified in 5.2.2.9;

1> if the rn-SubframeConfig is included:

2> reconfigure lower layers in accordance with the received subframeConfigPatternFDD or subframeConfigPatternTDD;

2> if the rpdcch-Config is included:

3> reconfigure lower layers in accordance with the received rpdcch-Config;

1> submit the RNReconfigurationComplete message to lower layers for transmission, upon which the procedure ends;