Ubuntu – Trim and SSD with usb 3.0 enclosure does not work – UASP not supported


I have installed one SSD disk (Micron C400-MTFDDAC128MAM) in an external usb 3.0 enclosure. Now I want use this disk as second disk in my laptop with Ubuntu 12.04. Disk is working, but I want to use TRIM suppport which is not working as expected.

Check for trim support:

user@server:~$ sudo hdparm -I /dev/sdc | grep -i TRIM
       *    Data Set Management TRIM supported (limit 8 blocks)
       *    Deterministic read data after TRIM

Disk was mounted with following options:

/dev/sdc1 on /media/MICRON type ext4 (rw,nosuid,nodev,uhelper=udisks)

But when I run the trim command manually I get an error:

user@server:~$ sudo fstrim -v /media/MICRON/
fstrim: /media/MICRON/: FITRIM ioctl failed: Operation not permitted

I used this disk before as an internal disk and trim was working, please assist me thank you.

here some USB details:

[ 1039.248050] usb 4-1: new SuperSpeed USB device number 4 using xhci_hcd
[ 1039.265597] scsi8 : usb-storage 4-1:1.0
[ 1041.547879] scsi 8:0:0:0: Direct-Access     C400-MTF DDAC128MAM       0509 PQ: 0 ANSI: 5
[ 1041.549134] sd 8:0:0:0: Attached scsi generic sg2 type 0
[ 1041.550511] sd 8:0:0:0: [sdc] 250069680 512-byte logical blocks: (128 GB/119 GiB)
[ 1041.550778] sd 8:0:0:0: [sdc] Write Protect is off
[ 1041.550785] sd 8:0:0:0: [sdc] Mode Sense: 23 00 00 00
[ 1041.552520] sd 8:0:0:0: [sdc] No Caching mode page present
[ 1041.552528] sd 8:0:0:0: [sdc] Assuming drive cache: write through
[ 1041.554029] sd 8:0:0:0: [sdc] No Caching mode page present
[ 1041.554035] sd 8:0:0:0: [sdc] Assuming drive cache: write through
[ 1041.678373]  sdc: sdc1
[ 1041.679982] sd 8:0:0:0: [sdc] No Caching mode page present
[ 1041.679991] sd 8:0:0:0: [sdc] Assuming drive cache: write through
[ 1041.679997] sd 8:0:0:0: [sdc] Attached SCSI disk

How to find out if the mass storage device using the UASP (USB Attached SCSI Protocol) which should support TRIM?

Kind regards


Best Answer

  • Your SSD reports to hdparm to support TRIM (hdparm -I = Request identification info directly from the drive).

    TRIM however, is controlled by the drive controller.

    It is quite likely that the USB3 harddiskcontroller of the external HDD closure doesn't support TRIM (most external controllers don't).

    In that case you won't get any TRIM capabilities even if your SSD does support it.

  • Related Question